Table of Contents
Advertisement
At any point you may enter a question mark '?' followed by 'Enter' for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Type y and press Enter.
Step 4
The system configuration dialog begins.
Initial System Configuration
Upon initial connection to the local terminal, as described above, the system configuration wizard automatically runs to
guide the user through the entire setup process. The wizard prompts for all necessary parameters, displaying default
values, where applicable. You may accept the default values or define other values.
With the exception of the time settings, which take effect immediately when entered, the new configuration is applied and
saved only at the end of the dialog when approved by the user. Therefore, if the setup dialog is aborted, no change takes
place in the configuration, other than time settings (if entered).
When the dialog is complete, you may review the new configuration before applying it. The system displays the
configuration, including parameters that were not changed. The system also displays any errors that are detected in the
configuration. When the configuration is satisfactory, you may apply and save the new configuration.
The following table lists all the parameters included in the initial configuration. It is recommended that you obtain values
for any parameters that you will configure at this time before beginning the setup.
Note
For further information regarding any configuration step or specific parameter, refer to the relevant section in the Cisco
Service Control Engine (SCE) Software Configuration Guide.
Setup Command Parameters
Table 5-1
Setup Command Parameters
Parameter
IP address
subnet mask
default gateway
hostname
admin password
16
--- System Configuration Dialog ---
Definition
IP address of the SCE 2000.
Subnet mask of the SCE 2000.
Default gateway.
Character string used to identify the SCE 2000. Maximum 20 characters.
Admin level password.
Character string from 4-100 characters beginning with an alpha character.
Advertisement
Table of Contents
