Cisco 2431 - IAD Router Software Configuration Manual page 35

Configuring with the Command-Line Interface
This chapter describes how to use the Cisco IOS software command-line interface (CLI) to configure
basic Cisco integrated access device (IAD) functionality.
This chapter presents the following major topics:
Configuring the Hostname and Password, page 3-2
•
Configuring Fast Ethernet Interfaces, page 3-4
•
Configuring Network Clock, page 3-5
•
Configuring T1/E1 Interfaces, page 3-7
•
• Configuring a WIC-1DSU-T1/E1 Serial WAN Interface Card, page 3-20
• Configuring a WIC-1T or WIC-2T Serial WAN Interface Card, page 3-24
• Configuring a VIC2-2FXO or VIC2-4FXO Voice Interface Card, page 3-24
Configuring a VIC2-2FXS or VIC2-4FXS Voice Interface Card, page 3-26
•
Configuring ATM T1-WAN Ports, page 3-28
•
Configuring 1-Port ADSL/SHDSL WAN Interface Card, page 3-32
•
Configuring a VIC2-2BRI-NT/TE Card, page 3-36
•
Saving Configuration Changes, page 3-38
•
Follow the procedures in this chapter to configure the Cisco IAD manually or, if you wish, to change the
configuration after you have run the setup command facility (see the
section on page
This chapter does not describe every configuration possible-only a small portion of the most commonly
used configuration procedures. For advanced configuration topics, see the Cisco IOS configuration
guide and command reference publications. See the
Service Request" section on page
Note If you skipped
Cisco IAD, return to
contains important information that you need for configuring your Cisco IAD.
The Cisco IAD2435 router is a fixed-configuration router and does not support interface cards.
Note
OL-4306-03
2-2).
-ix.
Chapter 2, "Using the setup Command Facility,"
Chapter 2, "Using the setup Command Facility,"
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
3
C H A P T E R
"The setup Command Facility"
"Obtaining Documentation and Submitting a
and you have never configured a
and read it now. The chapter
3-1