Cisco 2431 - IAD Router Software Configuration Manual page 30

Configuring Controller and Interface Parameters
T1 is capable of being configured for channel 1-24
Enter number of time slots [24]: 3
Configure more channel groups? [no]: y
Enter number of time slots [21]: 3
Configure more channel groups? [no]: y
Enter number of time slots [18]: 3
Configure more channel groups? [no]: y
Enter number of time slots [15]:
Configure more channel groups? [no]:
The
show the prompts and provide examples for configuring each encapsulation type. No further
configuration is needed for HDLC encapsulation.
Sample configuration for the following encapsulation types are provided in this section:
•
•
•
•
PPP Encapsulation
The following is an example of a typical PPP encapsulation configuration:
Would you like to enable multilink PPP [yes]:
Enter a remote hostname for PPP authentication [Router]:
Enter a password for PPP authentication:
The password, which is used by the Challenge Handshake Authentication Protocol (CHAP)
Note
authentication process, is case sensitive and must exactly match the remote router's password.
Frame Relay Encapsulation
The following is an example of a typical Frame Relay encapsulation configuration:
The following lmi-types are available to be set,
when connected to a frame relay switch
Enter lmi-type [2]:
The setup command facility prompts for the data-link connection identifier (DLCI) number only if you
Note
specify none for the Local Management Interface (LMI) type. If you accept the default or specify
another LMI type, the DLCI number is provided by the specified protocol.
Enter the DLCI number for this interface [16]:
Do you want to map a remote machine's IP address to dlci? [yes]:
IP address for the remote interface: 2.0.0.2
Do you want to map a remote machine's IPX address to dlci? [yes]:
IPX address for the remote interface: 40.1234.5678
Serial interface needs clock rate to be set in dce mode.
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
2-10
"PPP Encapsulation" section on page 2-10
PPP Encapsulation
Frame Relay Encapsulation
LAPB Encapsulation
SMDS Encapsulation
[0] none
[1] ansi
[2] cisco
[3] q933a
Chapter 2
through the "SMDS Encapsulation" section on page 2-11
Using the setup Command Facility
OL-4306-03