Configuring Controller and Interface Parameters
Fast Ethernet WAN Interface Configuration
This section provides sample steps and configuration for the Fast Ethernet WAN interface.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router# enable
Step 2
configure terminal
Example:
Router# configure terminal
Step 3
interface type/number
Example:
Router(config)# interface fastethernet 2
Router(config-if)#
Step 4
ip address ip address/subnet mask
Example:
Router(config-if)# ip address 192.168.12.2
255.255.255.0
Router(config-if)#
Cisco IAD2430 Series Integrated Access Devices Software Configuration Guide
2-6
enable
configure terminal
interface type/number
ip address ip address/subnet mask
no shutdown
end
Chapter 2
Purpose
Enters privileged EXEC mode.
Enters global configuration mode.
Enters the configuration mode for a Fast Ethernet WAN
interface on the router.
Sets the IP address and subnet mask for the specified Fast
Ethernet interface.
Using the setup Command Facility
OL-4306-03