Installing The M.2 Storage Module - Cisco Catalyst 8300 Series Hardware Installation Manual

Installing the M.2 Storage Module

Installing the M.2 Storage Module
The M.2 storage modules come with different storage capacities and can be replaced through the front panel
if required.
These are the steps to upgrade the M.2 storage module:
1. Power off of the system before replacing M.2.
2. Locate the M.2 storage module slot. Refer to
Figure 24: M.2 storage module slot
3. Loosen the screws that secures the M.2 blank cover or existing M.2 module in the slot. Remove the blank
cover or existing module.
Note
4. Plug in the new M.2 storage module in the same location and secure it with the screws.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
34
The disk used in M.2 is also the boot disk. If you replace the M.2 disk, you must reinstall Cisco NFVIS
operating system once again.
Install and Upgrade Field Replaceable Units
Chassis - Front Panel to identify and locate the module.