Cisco Catalyst 8300 Series Hardware Installation Manual page 22

Installing the Cisco Catalyst 8300 Series Edge uCPE
Figure 9: Desktop-mounting the chassis
1
2
Rack-Mounting the Chassis
The Cisco Catalyst 8300 Edge uCPE can be installed in 19-inch (48.26-cm) or 23-inch (58.42-cm) racks. The
mounting ears for the device are designed for #12 screws for securing to the rack.
The device can be rack-mounted in the following ways:
• Front (I/O-face) mounting: Brackets attached at the front of the chassis with the front panel (I/O) facing
forward
• Back (PSU-side) mounting: Brackets attached at the back of the chassis with the back (PSU-side) panel
facing forward
Attaching Brackets to the Chassis
Attach one mounting bracket to each side of the device as shown in following figures. Four screws are required
to attach each bracket to the device. Screws are provided with the mounting kit to attach the screws to the
device.
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
18
Install the Cisco Catalyst 8300 Series Edge uCPE
Rubber feet
Circular markings for placing the feet