Cisco Catalyst 8300 Series Hardware Installation Manual page 11

Overview of Cisco Catalyst 8300 Series Edge uCPE
LED Definition
BMC Management port Link LED
LED
PWR (1 LED)
STATUS (1 LED)
ENV (1 LED)
Beacon (1 LED)
Status Indicators and LEDs for Gigabit Ethernet Ports
Color
Green
Behavior
Red/Yellow LED1
Red/Green/Yellow LED2
Red/Green/Yellow LED3
B LED4
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Description
BMC Management Ethernet
Link LED Off: No link, Green:
ethernet cable present and link
established with other side
Description
Power supply status LED Off:
The system is powered off
Amber (Green + Red)- A PSU in
system is not functioning correctly
Green- All installed PSUs are
operating correctly
Status LED GREEN- x86 booted
fine
Amber- x86 in rommon mode
(setup menu) Red blinking — x86
Secure boot failure
Red- x86 is UP but BIOS is not
fully UP yet (bios post cmplt not
set)
Off- x86 in power-off state
ENV LED
Off- Monitor is not active.
Red- The system has detected a
critical overcurrent event and may
shut down.
Blinking Amber- One or more
temperature sensors in the system
are outside the acceptable range.
Amber- One or more fans in the
system are outside the acceptable
range.
Green- All temperature sensors and
fans in the system are within
acceptable range.
Beacon LED
Off- Default state
Blue- The administrator can light
to show the router needs attention
7