The External Optical Bypass Module Front Panel; Installing The External Bypass Module - Cisco SCE 2000 4xGBE Installation And Configuration Manual

Appendix A The External Optical Bypass Module

The External Optical Bypass Module Front Panel

The front panel of the External Optical bypass module contains the following components:
Figure A-3: External Optical Bypass Module

Installing the External Bypass Module

Installation of the External Optical Bypass module requires two main steps, which are described
in detail in the following sections.
To install the External Optical Bypass module:
Install the module in the rack.
Step 1
Step 2 Cable the module.
OL-7824-04
SUB Rx/Tx — GBE port that connects to the network element on the Subscriber side of the
•
link.
NET Rx/Tx — GBE port that connects to the network element on the Network side of the
•
link.
• CONTROL — RJ-45 port that connects to the Bypass connector on the rear panel of the
SCE 2000 platform. The SCE 2000 platform controls the External Optical Bypass module
via this connection, by the presence or absence of electrical power.
Pigtail fiber connectors — Four fiber cables that connect to the GBE link ports on the front
•
panel of the SCE 2000 platform
NET Tx
•
NET Rx
•
• SUB Tx
SUB Rx
•
No Bypass LED:
•
ON = Bypass module is not active (GBE traffic flows through the SCE 2000 platform)
•
• OFF = Bypass module is active (GBE traffic flows through the bypass module)
The External Optical Bypass Module Front Panel
Cisco SCE 2000 4xGBE Installation and Configuration Guide
A-3