Installing An Optical Bypass Module - Cisco SCE8000 Installation And Configuration Manual

Chapter 4 Installing the Cisco SCE8000 Chassis
Figure 4-14
Install the eight (four per side) 12-24 x 3/4-inch or 10-32 x 3/4-inch screws through the holes in the
Step 4
bracket and into the threaded holes in the equipment rack posts.
Use a tape measure and level to verify that the chassis is installed straight and level.
Step 5

Installing an Optical Bypass Module

There are two installation options for the external bypass modules:
•
•
For external mounting, install the external mounting panel in the 19" rack. Screw the mounting panel to
Step 1
the rack using four 3/4-inch screws, two on each side, through the holes in the mounting panel and into
the threaded holes in the rack posts.
For internal mounting, the SCE8000 chassis will be shipped with the chassis mounting panel already
installed in slot #4.
OL-16478-03
Installing the Cisco SCE8000 Chassis in the Rack
FA N ST SCE 8000
-SCM -E
AT US
1
SC M
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACTI VE
SCE 8000
-SCM -E
SC M 2
OPT ICAL
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACTI VE
SCE 8000
-SIP
SIP 3
4
TX
SC E8 00
TX
0- FA N
TX
RX TX A C
B D
RX
A B
RX
C
RX D
STA TUS
OP TIC AL
BY PA SS
1
Chassis mount panel—This panel is mounted on slot #4 of the SCE8000 chassis. It hosts two optical
bypass modules, which will serve the two traffic links supported by one Cisco SCE8000 chassis.
External mounting panel—This panel can be mounted in any 19" rack. It hosts up to four optical
bypass modules, which will serve the four traffic links supported by two Cisco SCE8000 platforms.
STA TUS
OPT ICA
L BYP ASS
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MA STE R
SYS TEM
POW ER
STA TUS
OPT ICA
L BYP ASS
SCE8 000
EXTE NDED
SERV ICE
CONT ROL
MA STE R
SYS TEM
POW ER
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
SPA- 1X10
GE-L -V2
CTR L
SPA- 1X10
GE-L -V2
OP B-S
CE 8K -M
M
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Installing the Cisco SCE8000 Chassis in the Rack
MOD ULE
MOD ULE
4-17