Cisco Catalyst 8300 Series Hardware Installation Manual page 25

Install the Cisco Catalyst 8300 Series Edge uCPE
Figure 12: Rack mount brackets applied flush to PSU-side
1
Mounting the Device in a Rack
Afteryou secure the brackets to the device, install the chassis in the rack as shown in following figures. Four
screws are required to secure in the rack. The screws for attaching the device to the rack are not provided with
the kit.
Tip
For both the 19-inch EIA brackets and 23 inch brackets, start the lower pair of screws first, and the rest of the
brackets are on the lower screws while you insert the upper pair of screws.
Tip
The screw slots in the brackets are spaced to line up with every second pair of screw holes in the rack. When
the correct screw holes are used, the small threaded holes in the brackets line up with unused screw holes in
the rack. If the small holes do not line up with the rack holes, raise or lower the brackets to the next rack hole.
Installing the Cisco Catalyst 8300 Series Edge uCPE
Rack-mount bracket
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
21