Removing A Dimm; Installing The M.2 Storage Module - Cisco Catalyst 8300 Series Hardware Installation Manual

Install and Upgrade Field Replaceable Units
4. Orient the DIMM so that the polarization notch lines up with the polarization key on the connector.
5. Insert the DIMM into the connector.
6. Replace the chassis cover.

Removing a DIMM

These are the steps to remove a DIMM:
1. Remove the chassis cover.
2. Locate the DIMM module on the device. Refer to the
DIMM module.
3. Pull the latches away from the DIMM at both ends to lift the DIMM slightly. Pull the DIMM out of the
socket.
4. Place the DIMM in an antistatic bag to protect it from ESD damage.
5. Replace the chassis cover.

Installing the M.2 Storage Module

The M.2 storage modules come with different storage capacities and can be replaced through the front panel
if required.
Chassis-Internal
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Removing a DIMM
section to identify and locate the
31