Install and Upgrade Field Replaceable Units
Figure 29: Securing the E1.S module in the chassis
Note
Keep the drive bays covered when there are no drives installed in the slot
SSD 2.5-inches Drives
Note
The drive bays are in the front panel of the device. The bays are closed with a cover if there are no drives in
the slots.
1. Remove the blank in the SSD slot
2. Install the drive into the slot and push forward until the drive seats in the connector
3. To secure the drives in the chassis, secure the screws on each side of the drive faces
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
Installing Drive Bays
39