Cisco Catalyst 8300 Series Hardware Installation Manual page 31

Install the Cisco Catalyst 8300 Series Edge uCPE
Figure 18: Showing the securing of brackets to the side of the device for wall-mounting
1
2
3
2. Fix the chassis to the wall using the brackets that you attached to the device.
The screws or anchors for attaching the device to the wall are not provided with the kit. Depending on
the type of wall (wood, brick, stone etc), use appropriate screws or anchors to fix the device to the wall.
Note
Route the cables so that they do not put a strain on the connectors or mounting hardware. For safety reasons,
the chassis may only be mounted with ports going out in left or right direction. Do not mount the chassis with
ports facing upward or downward direction.
Installing the Cisco Catalyst 8300 Series Edge uCPE
Mounting bracket
Securing screws
Bushings
Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide
27