Connecting The Rf Cables To The Chassis; To Connect Rf Cables For Each Module - Cisco Prisma II EDR Installation Manual

Connecting the RF Cables to the Chassis

To Connect RF Cables for Each Module

Complete the appropriate procedure in this section to connect RF cables for the
module.
Note: This procedure assumes that the chassis is mounted in a rack.
Standard Prisma II Chassis
Note: This procedure assumes that you are using a host module with application
modules installed in both lower and upper half-slot positions. If only one module is
installed, it is not necessary to connect RF cables for the unused position.
1 Locate the RF ports on the chassis connector panel. The connector panel is on the
front of a front-access chassis, and on the rear of a rear-access chassis. The figure
below shows the connector panel for a rear-access chassis.
2 Connect RF cables to the Port A and Port C connectors for the chassis slot in
which the host module will be installed. These are the RF output connections for
the module in the lower half-slot position. Hand-tighten the connectors.
3 Route the RF cables from Ports A and C (for the lower half-slot module) to the
appropriate RF destinations.
OL-32414-01

Connecting the RF Cables to the Chassis

23