Cisco SCE8000 Installation And Configuration Manual page 28

The Cisco SCE8000 Optical Bypass
Optical Bypass Module (OPB-SCE8K)
There are two types of optical bypass modules to support different optic types:
•
•
The optical bypass module is installed either internally, in slot #4 of the Cisco SCE8000 chassis or in an
external mounting panel in the rack.
Up to two optical bypass modules can be mounted internally, supporting inline insertion into two links.
Up to four optical bypass modules can be mounted using an external mount panel
(OPB-SCE8K-EXT-PNL). A single panel can serve two SCE8000 platforms, each cutting two links or
up to four SCE8000 platforms, each cutting a single link.
Figure 2-8
Table 2-8
Port
10 GBE Line
port
CTRL
Table 2-9
LEDs
Status
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
2-10
OPB-SCE8K-SM supports Single-Mode optics and should be used with SCE8000 equipped with
Single-Mode optics.
OPB-SCE8K-MM supports Multi-Mode optics and should be used with SCE8000 equipped with
Multi-Mode optics.
Optical Bypass Module
TX TX TX TX
RX RX RX RX
A B C
Optical Bypass Module Ports
Quantity
4
1
Optical Bypass Module LEDs
Description
The Status LED indicates the operational status of the optical bypass
module, as follows:
•
•
A C
CTRL
D
B
A B
C D
STATUS
D OPB—SCE8K—MM
Description
10GBE ports A through D
Duplex LC, panel mount adaptor
for LC/UPC connectors
RJ-11 port
Green — Bypass module has been de-activated (traffic flows through the
Cisco SCE8000 platform)
Off — Bypass module is active (traffic does not flow through the Cisco
SCE8000 platform)
Chapter 2 Introduction to the Cisco SCE8000 Platform
Connect This Port To...
SPA interfaces on the Cisco
SCE8000.
Refer to Cabling the 10GBE
Line Interface Ports: Using the
External Optical Bypass
Module, page 6-11
information.
RJ-11 Optical Bypass port on the
SCE8000-SCM-E
for further
OL-16478-03