Installing The Cisco Sce8000 Chassis In The Rack - Cisco SCE8000 Installation And Configuration Manual

Chapter 4 Installing the Cisco SCE8000 Chassis
Table 4-6
Task No.
3
4
5
6

Installing the Cisco SCE8000 Chassis in the Rack

This section describes how to install a Cisco SCE8000 platform in a rack. For first-time installations,
perform the procedures in the following sections in the order listed:
•
•
•
•
•
•
Before starting the installation procedures in this chapter, see the
Note
page
OL-16478-03
Site Planning Checklist (continued)
Planning Activity
Power evaluation:
Input power type
Power receptacles
Receptacle proximity to the equipment
Dedicated (separate) circuits for redundant power
supplies
UPS for power failures
DC systems: Proper gauge wire and lugs
Grounding evaluation:
Circuit breaker size
CO ground (AC- and DC-powered systems)
Cable and interface equipment evaluation:
Cable type
Connector type
Cable distance limitations
EMI evaluation:
Distance limitations for signaling
Site wiring
RFI levels
Unpacking the Cisco SCE8000 Chassis, page 4-14
Installation Guidelines, page 4-14
Required Tools, page 4-15
Installing the Chassis Brackets, page 4-15
Installing the Chassis in the Rack, page 4-16
Installing an Optical Bypass Module, page 4-17
4-12section to verify that all site planning activities were completed.
Installing the Cisco SCE8000 Chassis in the Rack
Verified By Time
Site Planning Checklist,
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Date
4-13