Removing And Replacing The Fan Assembly; Required Tools; Removing The Fan Assembly - Cisco SCE8000 Installation And Configuration Manual

Chapter 9 Removal and Replacement Procedures
Turn on the DC inputs and verify power supply operation by checking the power supply front panel
Step 11
LEDs.
The power supply rear panel LEDs should be in the following states:
•
•
•
If the LEDs indicate a power problem, see

Removing and Replacing the Fan Assembly

This section describes how to remove and replace fan assemblies for the Cisco SCE8000 chassis.
•
•
•

Required Tools

A flat-blade or number 2 Phillips-head screwdriver is required to perform this procedure.

Removing the Fan Assembly

The fan assembly is designed to be removed and replaced while the system is operating without
presenting an electrical hazard or damage to the system.
Loosen the two captive installation screws by turning them counterclockwise.
Step 1
OL-16478-03
INPUT OK LED is green
FAN OK LED is green
OUTPUT FAIL LED is not lit
Required Tools, page 9-11
Removing the Fan Assembly, page 9-11
Installing the Fan Assembly, page 9-12
Removing and Replacing the Fan Assembly
Identifying Startup Problems, page 8-6
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
9-11