Installing The Cwdm Passive Optical System - Cisco CWDM-OADM 1 Series Installation Notes

Installing the CWDM Passive Optical System

The following sections provide installation procedures for the CWDM passive optical system
components:
•
•
•
•
•
Required Tools
You will need these tools to install the CWDM passive optical system:
•
•
•
•
•
•
Installing the 2-Slot Chassis (CWDM-CHASSIS-2=)
Ensure that you install the 2-slot chassis in the same rack or an adjacent rack to your system so that you
Note
can connect all the cables between your CWDM OADM modules and the CWDM GBIC and CWDM
SFP transceivers in your system.
Caution When performing the following procedures, wear a grounding strap to avoid ESD damage to the OADM
module. Some platforms have an ESD connector for attaching the wrist strap.
To mount the 2-slot chassis in an equipment rack, follow these steps:
Remove the 2-slot chassis from the shipping packaging.
Step 1
Position the 2-slot chassis in the rack where you are going to install it. Align the mounting holes in the
Step 2
chassis L brackets with the mounting holes in the equipment rack to ensure that the 2-slot chassis is
mounted straight and level. Use a level or tape measure to verify that the chassis is positioned level in
the rack.
78-16565-02
Required Tools, page 15
Installing the 2-Slot Chassis (CWDM-CHASSIS-2=), page 15
Installing the CWDM OADM Modules, page 16
Removing the CWDM OADM Module, page 17
Installing and Removing CWDM GBIC and CWDM SFP Transceivers, page 17
Number 2 Phillips screwdriver for the 10-32 or the 12-24 chassis installation screws.
Wrist strap or other personal grounding device to prevent ESD occurences.
Antistatic mat or antistatic foam to set the equipment on.
Fiber-optic end-face cleaning tools and inspection equipment. For complete information on
inspecting and cleaning fiber-optic connections, refer to the white-paper document at this URL:
http://www.cisco.com/en/US/tech/tk482/tk607/technologies_white_paper09186a0080254eba.shtml
Level (optional)
Tape measure (optional)
Installing the CWDM Passive Optical System
Cisco CWDM Passive Optical System Installation Note
15