Cisco SCE8000 Installation And Configuration Manual page 115

Chapter 8 Troubleshooting
.
Table 8-1 Cisco SCE8000 Operational States
Cisco SCE8000 Operational
Status
Booting
Operational
Warning
Failure
Table 8-2
LED Label
INPUT OK
OUTPUT FAIL
OL-16478-03
Description
Initial state after reset
Cisco SCE8000 becomes operational after completing the
following process:
Boot is completed
•
• Power-on self-tests are completed without failure
• Platform configuration is applied
Cisco SCE8000 is fully operational (as above) but one of the
following occurred:
GBE Management port link is down
•
Internal temperature above threshold
•
Internal voltage not in expected range
•
Fan problem
•
Power supply problem
•
Insufficient space on the disk
•
If the condition that caused the Cisco SCE8000 to be in
Note
Warning state is resolved (for example, link is up) the
Cisco SCE8000 reverts to Operational state.
System is in Failure state after Boot due to one of the following
conditions:
Power-on test failure
•
Three abnormal reboots in less than 30 minutes
•
Platform configured to enter Failure mode consequent to
•
failure-induced reboot (this is configurable using CLI
command)
Severe system health problem, such as extensive overheating
•
or voltage out of correct operating range.
Depending on the cause of failure, the management
Note
interface and the platform configuration may or may not be
active/available.
Power Supply LEDs
Color
Green
Green
State Function
On The input voltage is present and within the required
range.
Off The input voltage is not present or not within the
required range.
On The output voltage is not within the required range.
Off The output voltage is in the required range.
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Troubleshooting Overview
Status LED State
Amber
Steady green
Flashing amber
Red
8-5