Required Tools; Installing The Chassis Brackets - Cisco SCE8000 Installation And Configuration Manual

Chapter 4 Installing the Cisco SCE8000 Chassis

Required Tools

These tools and equipment are required to install the chassis in the rack:
•
•
•
•

Installing the Chassis Brackets

The chassis is shipped with the mounting brackets installed on the front of the chassis. These brackets
can be installed on the rear of the chassis.
To install the brackets on the rear of the chassis, perform these steps:
Remove the screws that secure the brackets to the chassis.
Step 1
Figure 4-13 Brackets on Cisco SCE8000 Chassis
FA N ST SCE 8000
-SC M-E
AT U S
SC M 1
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACT IVE
SCE 8000
-SC M-E
SC M 2
OPT ICA L
BYP ASS
CON SOL
E
POR T 1
10 100
LINK
1000
ACT IVE
SCE 8000
-SIP
SIP 3
4
TX
SC E8 00
0- FA N
RX
Position one of the brackets against the chassis side, and align the screw holes.
Step 2
Secure the bracket to the chassis with the screws removed in Step 1.
Step 3
Repeat Steps 2 and 3 for the other bracket.
Step 4
OL-16478-03
Number 1 and number 2 Phillips-head screwdrivers
3/16-inch flat-blade screwdriver
Tape measure and level
Masking tape or some other method of marking the desired installation height in the rack
STA TUS
OP TIC AL
BY PAS S
STA TUS
OP TIC AL
BY PAS S
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
TX
TX
A C
TX CT RL
B
RX D
A B
RX
C
RX D
ST AT US
OP TIC AL
BY PA SS
OP B- SC
1
E8 K- MM
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SCE 8000
EXTE NDE
D SER VICE
CON TRO
L MOD ULE
MA STE R
SYS TEM
PO WE R
SPA -1X1
0GE -L-V
2
SPA -1X1
0GE -L-V
2
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Installing the Cisco SCE8000 Chassis in the Rack
4-15