Checking The Leds - Cisco SCE8000 Installation And Configuration Manual

Troubleshooting Overview
Refer to
user log.

Checking the LEDs

The LEDS on the SCE8000-SMC-E front panel, along with the LEDs on the power supplies and fan
assembly are the most immediate problem-detection mechanism of the platform. Refer to the following
sections for information on Cisco SCE8000 platform LEDS:
•
•
•
•
Cisco SCE8000 Operational Status
The following table lists the operational states of the Cisco SCE8000. The Status LED on the Service
Control module reflects the current Cisco SCE8000 operational status. Once boot is complete, the
operational status can be displayed using CLI command show system operation-status
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
8-4
show interface TenGigabitEthernet 3/#/0 counters — Displays the values of counters of a
–
GBE interface.
Following is a sample output from the show interface counters command.
L2 In total octets: 792000
In good unicast packets: 12000
In good multicast packets: 0
In good broadcast packets: 0
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Rx pause packets: 0
L2 Out total octets: 0
Out unicast packets: 0
Out good multicast packets: 0
Out good broadcast packets: 0
Out packets discarded: 0
Tx pause packets: 0
Tx regular collision events: 0
L2 Bandwidth Kbps (Rx + Tx): 0
# of packets received of length (in octets):
64: 0, 65-127: 12000, 128-255: 0,
256-511: 0, 512-1023: 0, 1024-1518: 0,
1519+: 0
Troubleshooting with the User Log, page 8-11
Table 2-3 on page 2-3
Examining the LEDs, page 6-13
Starting the System and Observing Initial Conditions, page 7-2
Cisco SCE8000 Operational Status, page 8-4
Chapter 8
for an explanation of commands related to the
Troubleshooting
OL-16478-03