Example For Saving Or Changing The Configuration Settings - Cisco SCE8000 Installation And Configuration Manual

Chapter 7 Basic Cisco SCE8000 Platform Operations
To remove a configuration command from the running-config, use the no form of the command.
At the SCE# prompt, type show running-config to view the running configuration.
Step 1
The running configuration is displayed.
Check the displayed configuration to make sure that it is set the way you want. If not, make the changes
Step 2
you want before saving.
Type copy running-config startup-config.
Step 3
The system saves all running configuration information to the configuration file, which is used when the
system reboots.
The configuration file holds all information that is different from the system default in a file called
config.tx1 located in the directory: /system.

Example for Saving or Changing the Configuration Settings

The following example shows how to save the running configuration file (first displaying the file to
review the settings).
SCE#show running-config
#This is a general configuration file (running-config).
#Created on 12:06:13
#cli-type 1
#version 1
no management-agent notifications notification-list
1417,1418,804,815,1404,1405,1406,1407,1408,400
no management-agent notifications notification-list
402,421,440,441,444,445,446,450,437,457
no management-agent notifications notification-list 3593,3594,3595,10040
snmp-server community "public" ro
RDR-formatter forwarding-mode multicast
RDR-formatter destination 10.56.96.26 port 33000 category number 1 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 2 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 3 priority 100
RDR-formatter destination 10.56.96.26 port 33000 category number 4 priority 100
interface LineCard 0
connection-mode inline on-failure external-bypass
no silent
no shutdown
attack-filter subscriber-notification ports 80
replace spare-memory code bytes 3145728
interface GigabitEthernet 1/1
ip address 10.56.96.46 255.255.252.0
interface TenGigabitEthernet 3/0/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/1/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/2/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
interface TenGigabitEthernet 3/3/0
bandwidth 10000000 burst-size 50000
global-controller 0 name "Default Global Controller"
exit
OL-16478-03
UTC SUN May 11 2008
Cisco SCE8000 Installation and Configuration Guide, Rel 3.1.7
Managing Cisco SCE8000 Configurations
7-7