Casio IT-9000 Series Service Manual page 95

(3) Arrange the shape of the MCR cable at 2 places.
[ NOTE ] While holding the calble so that its contacts can be seen, arrange the shape of
the calbe to be in parallel with the clear plate, as shown below.
[ NOTE ] During arranging, pay attention so as not to damage the adhisive part of the
clear plate.
(4) Peel off the release paper from double-sided tape (MCR-TAPE), and then pass the MCR
cable through the hole.
[ NOTE ] Assemble the MCR so that its cable does not run the area shown by the square.
[ NOTE ] Pass the MCR cable through the hole while facing up its contacts as shown below.
[ NOTE ] After assembling, check the MCR cable.
OK:
Cable runs to the left smoothly.
(5) Stick the MCR-SPACER.
(6) Stick the FPC-PLATE.
FPC-PLATE
NOTE
– 88 –
NOTE
NG:
Cable runs downward once.
MCR-SPACER
IT-9000