Casio IT-9000 Series Service Manual page 73

<Checking by information display>
No. Operation
Select "Start" – "GPS
Information" in that order.
Select "Status" tab.
[ NOTE ]
If GPS information is not
display, move IT-9000 to the
open air where entire sky can
be seen.
(To receive and display the
information from the satellite,
it will take about one to fi ve
minutes.)
Satellite
1
Select "Position" tab.
2
Display
– 66 –
IT-9000
Test Details
Displays the information of the
satellite from which the signal is
being received.
Quality:
Displays the targeted
positioning. "GPS" is displayed
if the power to the GPS module
is on.
Selection:
"Auto" is displayed if the GPS
module is turned ON.
FixType:
Displays the reliability of the
positioning data. Either "3D
(3D positioning)", "2D (2D
positioning" or "– (positioning is
not possible)" is shown.
Received:
Display the time set by the
signal received satellite.
S/N Radio:
The satellite number is shown
on the left while, on the right,
the intensity of that satellite's
signal is indicated in the form
of bar graph. As the signal
becomes stronger, the bar
extends toward the right.
Displays the position information
received from the satellite.
Latitude:
Displays the latitude obtained
by positioning.
Longitude:
Displays the longitude obtained
by positioning.
Heading:
Displays the traveling direction
found out by positioning.
Speed:
Displays the traveling speed
found out by positioning.
Always North top:
When checked, the displayed
direction is always shown with
north on top.
Disp Satellites:
When checked, the satellite
position is displayed.
Disp Heading Arrow:
When checked, the traveling
direction is displayed with a red
arrow.