Digicom Michelangelo LAN Manual page 29

•
Cost
•
TimeOut
To remove a static IP address, click on the label listed on the table and click Remove.
To remove all the static IP addresses, click
ii) Click Close to save the configurations and exit.
Enter the value for cost. This refers to the number of hops
counted as the cost of the route, which may affect the
choice of route when the route is competing with routes
acquired from RIP. (But note that using a mixture of RIP and
static routing is not advised.) Default is 1.
Enter the value for timeout (in seconds). This specifies the
length of time before the route entry timeouts. Default of
0 means the route entry will never timeout.
Remove
Software Manual
All.
2 9