Digicom Michelangelo LAN Manual page 25

For Multiple PVCs:
viii) For multiple PVCs, click
- In the Protocol
will be based on RFC 1483 Bridged Protocol)
- In the IP Address
Mask addresses assigned to you by your ISP / System Administrator.
(The WAN IP Configuration must be a unique IP address for different set of PVC
values.)
Depending on your ISP, you may select the option
Automatically.
Gateway fields will be grayed out. The addresses will be allocated by your ISP
Server automatically.
- In the PVC
- Select the NAT
click Inbound
- Select the Framing Mode
- Click Add. A protocol with the new PVC values will be listed.
(To remove a PVC value, click on the respective protocol and click Remove.)
- Click Apply
see a dialog box,
Multiple PVC.
field, select your desired protocol. (The following instructions
section, enter the WAN IP Configuration
The WAN IP Configuration,
field, enter the new VPI and VCI values.
option as determined by your System Administrator. If required,
and fill in the data. (See
option as determined by your ISP..
for changes to take effect. Upon configuration successful, you will
'Configuration Successful' prompted. Click OK.
Software Manual
and WAN Subnet
Obtain Wan Setting
WAN Subnet Mask and
section 3.1.1a - NAT Inbound)
Remote
2 5