Digicom Michelangelo LAN Manual page 21

For Multiple PVCs:
vi) For multiple PVCs, click
- In the Protocol
- In the IP Address
Mask addresses assigned to you by your ISP / System Administrator.
(The WAN IP Configuration must be a unique IP address for different set of PVC
values.)
- In the PVC
- Select the NAT
click Inbound
- Select the Framing Mode
- Click Add. A protocol with the new PVC values will be listed.
(To remove a PVC value, click on the respective protocol and click Remove.)
- Click Apply
see a dialog box,
vii) Click Apply for changes to take effect. Upon configuration successful, you will see a
dialog box, 'Configuration
viii) Click Close to save the configurations and exit.
Multiple PVC.
field, select RFC 1483
section, enter the WAN IP Configuration
field, enter the new VPI and VCI values.
option as determined by your System Administrator. If required,
and fill in the data. (See
option as determined by your ISP..
for changes to take effect. Upon configuration successful, you will
'Configuration Successful' prompted. Click OK.
Successful' prompted. Click OK.
Software Manual
Routed.
and WAN Subnet
section 3.1.1a - NAT Inbound)
2 1