Configuring For Rfc 2225 (Rfc 1577) - Digicom Michelangelo LAN Manual
Router commander
Hide thumbs
Also See for Michelangelo LAN:
- User manual (41 pages) ,
- Quick manual (2 pages) ,
- User manual (21 pages)
Table of Contents
Advertisement
Software Manual
3 . 1 . 3
Configuring for RFC 2225 (RFC 1577)
i)
Select
Line Configuration
ii)
In the
PVC
section, enter the
iii)
In the
IP Address
section, enter all the required IP addresses assigned to you by your
ISP / System Administrator.
(Depending on your ISP, you may select the option
The
WAN IP
Configuration,
grayed out. The addresses will be allocated by your ISP Server automatically.)
iv)
Select the
NAT
option as determined by your System Administrator. If required, click
Inbound
and fill in the data. (See
v)
Click
Apply
for changes to take effect. Upon configuration successful, you will see a
dialog box,
'Configuration
vi)
Click
Close
to save the configurations and exit.
To change the LAN IP address / LAN Subnet Mask at the
/
LAN Subnet Mask
2 2
tab. In the
Protocol
field, click
VPI
and
VCI
values assigned by your ISP.
Obtain Wan Setting
WAN Subnet Mask
and
section 3.1.1a - NAT
Successful' prompted. Click OK.
field, read the Note on page 15.
RFC
1577.
Automatically.
Remote Gateway
fields will be
Inbound)
LAN IP Configuration
Advertisement
Table of Contents
