Setting Extended Re-Entry - Sony XVS-G1 User Manual

change the keys to enable in the Common > Key
Priority/Key Assign menu of the switcher bank.
For details, see "To change program output key
assignments" (page 182).
6
Press [OK].
Setting the key preview output
You can select the key preview output mode (video mode
or key mode) and the background/key to display.
Note
Key preview does not support SL keys.
1
Open the Home > Setup > Switcher > Config >
K-PVW Config menu (19103.14).
2
Select the target program output to set.
3
Press the [Mode] button and select a key preview
mode from the pull-down list.
Video: Video mode (key + background)
Key: Key mode (key only)
When [Key] is selected, proceed to step 5.
4
Press the [Background] button and select a
background from the pull-down list.
You can select the following backgrounds.
Standard mode: Clean
Multi program mode: Clean, Utility2
Multi program 2 mode: Clean, Sub Clean
DSK mode: DSK Background 1 to 4
5
Press the [Edit] button for [Key Preview Config].
The [Key Preview Config] window appears.
6
Press the button for the target key and select a display
mode from the pull-down list.
Link: Key display/non-display is linked to key on/off.
On: Display key.
Off: Do not display key.
7
Press [OK].
Setting a DSK mode background
In DSK mode, you can select a switcher bank output to
assign to a background (Background 1 to 4).
1
Open the Home > Setup > Switcher > Config > DSK
Bkgd Assign menu (19103.15).
2
Select the target background to set.
3
Press the [Edit] button for [Assigned M/E Output].
The [M/E Output Assign] window appears.
4
Set the button for the target output to the on state.
5
Press [OK].
Setting the recall target for an effect
timeline/snapshot
When an effect timeline or snapshot is saved or recalled,
the settings data of the following menus becomes the
target.
• Home > Setup > Switcher > Config > M/E Config menu
(19103.12)
• Home > Setup > Switcher > Config > PGM Config menu
(19103.13)
• Home > Setup > Switcher > Config > K-PVW Config
menu (19103.14)
The settings are common to all switcher banks.
1
Open the Home > Setup > Switcher > Config > M/E
Config menu (19103.12).
2
Set the [Recall M/E Config] button to the on state.

Setting Extended Re-Entry

When extended re-entry is enabled, selection of re-entry
signals on the same switcher bank becomes possible.
In multi program 2 mode, selection of re-entry signals
between main and sub also becomes possible.
Notes
• The extended re-entry settings are common to all
switcher banks.
• Recursive re-entry may cause problems in the image.
• The selection order of re-entry signals affects the
number of lines by which the output signal is lowered.
1
Open the Home > Setup > Switcher > Config > M/E
Config menu (19103.12).
2
Set the [Extended M/E Re-Entry] button to the on
state.
3
Check the message, then press [OK].
308