Setting A Gpi Input - Sony XVS-G1 User Manual

Setting a GPI Input

You can configure the trigger type and action for each GPI
input.
GPI input via a network
On GPI inputs via a network, GPI control is performed
using serial tally protocol commands.
GPI inputs can be configured in the same way as parallel
input ports.
Note
This uses a serial tally port, hence the network port must
be configured for a serial tally port.
For details, see "Setting a Serial Tally" (page 345).
1
Open the Home > Setup > External Device > GPI
Input Assign > GPI Input Assign menu (19105.21).
2
Select the target GPI input to set.
3
Press the [Target Device] button and select a control
panel (Panel 1, Panel 2) to handle the GPI input from
the pull-down list.
4
Press the [Trigger Type] button and select a trigger
type from the pull-down list.
Rising Edge: Trigger on the rising edge of the input
pulse.
Falling Edge: Trigger on the falling edge of the input
pulse.
Any Edge: Trigger on an inversion of the input pulse.
Level: Trigger the specified action when the level of
the input pulse is low or high.
NOP (No Operation): Not triggered by an input
pulse.
5
Press the [Edit Action] button for [Action].
The [GPI Input Assign] window appears.
6
Select an action to set.
When the trigger type is other than [Level]
Select a tab to change the action type to display.
[PP/ME Cut] tab: Cut transition actions
[PP/ME Auto Transition] tab: Auto transition
actions
[FTB/Effect/SS/SB/Macro] tab: FTB, effect
timeline, snapshot, shotbox, and macro actions
[PP/ME Key SS Recall] tab: Key snapshot actions
[Aux Bus Override] tab: AUX bus override actions
Set the button for the target action to the on state.
When the trigger type is [Level]
Configure the action and high level/low level settings.
Press the [Action] button and select an action from the
pull-down list.
Press the [High Level] button and select a high-level
setting from the pull-down list.
Press the [Low Level] button and select a low-level
setting from the pull-down list.
Note
On GPI inputs via a network, the "System Format"
action is not supported when the trigger type is
[Level].
7
Press [OK].
To set action preferences
You can set action preferences when a register recall
action or AUX bus override action is selected.
1
Select the target GPI input to set.
2
Press the [Action Details] button for [Action Details].
The [Action Details] window appears.
3
Set the action preferences.
When a register recall action is selected
Press the [Register No.] button and enter a register
number in the numeric keypad window.
When an AUX bus override action is selected
Press the [Source No.] button and enter a source signal
(input signal) number in the numeric keypad window.
Note
Source signal numbers 45 to 48 cannot be used.
4
Press [OK].
Trigger type and actions list
When the trigger type is other than [Level]:
P/P Cut, P/P Sub Cut, P/P Keyx Cut, M/E-x Cut, M/E-x
Sub Cut, M/E-x Keyx Cut
P/P Auto Trans, P/P Sub Auto Trans, P/P Keyx Auto
Trans, M/E-x Auto Trans, M/E-x Sub Auto Trans, M/E-x
Keyx Auto Trans
FTB Cut, FTB Auto Trans, Effect Recall, Effect Recall &
Run, Effect TL Rewind, Effect TL Run, Effect TL Stop,
Snapshot Recall, Shotbox Recall, Macro Recall, Macro
Take
P/P Keyx SS Recall, M/E-x Keyx SS Recall, No Action
Auxx Bus Override
When the trigger type is [Level]:
No Action, System Format
332
1)
2)