Setting Key Drop - Sony XVS-G1 User Manual

No. Parameter
1 Size
2 Soft
5 Pattern
a) Linked to the pattern number selected using the [Mix Pattern Select]
button.
To set a single color, set the [Flat Color] button to the
on state.
Note
The [Flat Color] button parameters are shared with the
[Matte] button parameters in the [Edge Fill] group in
the Home > M/E-1 > Key1 > Edge > Edge Type Select
menu (11101.21).
3
Press the [Mix Pattern Select] button.
A pattern selection window appears.
Note
Dedicated patterns 1 to 24 are the same as standard
wipe patterns 1 to 24.
4
Set the button for the target pattern to the on state.
5
Press [OK].
6
Press the [Color 1] button and set color 1 using the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
Note
The [Color 1] button parameters are shared with the
[Matte] button parameters in the [Edge Fill] group in
the Home > M/E-1 > Key1 > Edge > Edge Type Select
menu (11101.21).
7
Press the [Color 2] button and set color 2 using the
following parameters.
No. Parameter
1 Luminance
2 Saturation
3 Hue
To swap color 1 and color 2 in a color mix
Set the [Color Invert] button to the on state.
Adjustment
Pattern size
Softness of the pattern contour
a)
Pattern number
Adjustment
Luminance
Saturation
Hue
Adjustment
Luminance
Saturation
Hue
To set modifiers for a dedicated pattern for a
color mix
You can set the following modifiers.
Position:
Set the [Position] button to the on state and set the
parameters.
For details about setting parameters, see "Setting the
wipe pattern position (Position)" (page 108).
Multiplication:
Set the [Multi] button to the on state and set the
parameters.
For details about setting parameters, see "Replicating
a wipe pattern (Multi)" (page 109).
Aspect:
Set the [Aspect] button to the on state and set the
parameters.
For details about setting parameters, see "Setting the
aspect ratio of a wipe pattern (Aspect)" (page 109).
Rotation (angle):
Set the [Angle] button in the [Rotation] group to the on
state and set the parameters.
For details about setting parameters, see "Rotating a
wipe pattern (Rotation)" (page 108).
Rotation (speed):
Set the [Speed] button in the [Rotation] group to the on
state and set the parameters.
For details about setting parameters, see "Rotating a
wipe pattern (Rotation)" (page 108).

Setting Key Drop

Setting key drop on mode
You can set key drop on mode and select whether to move
the key fill/key source position downward by eight lines or
four lines.
Note
In the following situations, key drop on mode is
automatically enabled.
• When the edge type is border, outline, or emboss
• When fine key is enabled
• When soft edge is enabled
1
Open the Home > M/E-1 > Key1 > Edge > Edge Type
Select menu (11101.21).
2
Set the [Key Drop] button in the [Key Delay Mode]
group to the on state.
83