Enter values in the order year (YYYY), month (MM),
day (DD), hour (hh), minute (mm), and second (ss).
4
Press [Enter].
Setting the switcher to act as an NTP
server
When the switcher is configured to act as an NTP server,
an external device connected to the switcher can access the
NTP server.
1
Open the System Configuration > Date/Time > Date/
Time Settings menu (20301.11).
2
Set the [NTP Service for Ext Dev] button to the on
state.
To deny access, set the [NTP Service for Ext Dev]
button to the off state.
Firmware Version
Management and
Installation
Displaying Package Status
You can check information about the installed packages in
the System Configuration > Version > Info/Install menu
(20401.11).
Current System Version: Installed package version
Status: Version status within a package
"OK" is displayed if there is no mismatch.
"
Incorrect Version" is displayed if there is a
mismatch.
The following information is displayed for each switcher/
control panel.
Select a tab to change the switcher (Switcher)/control
panel 1 (Panel 1)/control panel 2 (Panel 2) display.
Module: Name of module within the switcher/control
panel
Version: Version of module
Date/Time: Modification date and time of module
The display of modification date and time may not be
supported depending on the module.
Installing a Package
Repairing a package mismatch
1
Open the System Configuration > Version > Info/
Install menu (20401.11).
2
Press the [Recover] button.
3
Check the message, then press [OK].
The switcher system reboots.
Note
Once the process has started, it cannot be undone.
Installing a package
1
Open the System Configuration > Version > Info/
Install menu (20401.11).
2
Press the [Add] button for [Install System Version].
A computer file selection dialog appears.
360