Control of Routers
Destination Input List Display
You can check destination inputs in the Home > External
Device > Router > Router Xpt menu (16104.11).
The assigned destination and source are displayed for each
destination selection delegation button (1 to 64).
Destinations that have Inhibit enabled are grayed out.
A lock icon is displayed for sources that have protection
enabled on the MKS-R3210/R1620 Remote Control Panel.
Notes
• Delegation button numbers 65 to 128 are not displayed.
• The destination assignment and inhibit settings are
configured in the Home > Setup > Panel > Router >
Delegation Button Assign menu (19104.51).
For details, see "Assigning a Destination" (page 323).
Selecting a Level
You can select the level used by the router.
For details about assigning the levels of level selection
buttons, see "Setting Levels" (page 323).
1
Open the Home > External Device > Router > Router
Xpt menu (16104.11).
2
In the [Level Button No./Level Assign] group, select a
level selection button to use.
Select one of the [Level 1] to [Level 4] radio buttons.
Switching the Destination Input
You can switch the source for a destination.
For details about creating a source table, see "Assigning
a Source Table" (page 323).
Note
Input switching is supported only for the destinations on
delegation button numbers 1 to 64.
1
Open the Home > External Device > Router > Router
Xpt menu (16104.11).
2
Select the target destination selection delegation
button to set.
3
Press the [Select Source] button.
A source selection window appears.
4
Switch the source using the source selection buttons.
Select a tab to change the button number to display.
Setting a source selection button to the on state
switches the source.
176