Setting A Dme Channel; Setting A User Region; Setting A Multi Viewer - Sony XVS-G1 User Manual

Setting a DME Channel

Setting a DME channel to use in a switcher
bank
You can set a DME channel to use on switcher bank for a
processed key or DME wipe.
1
Open the Home > Setup > Switcher > Config > DME
Config menu (19103.16).
2
Select the target switcher bank to set.
3
Press the [Edit] button for [DME Channel].
The [Select DME Channel] window appears.
4
Place a check mark in the DME channels to enable.
5
Press [OK].

Setting a User Region

You can assign the following regions to User 1 to User 8.
• Color Bkgd 1, Color Bkgd 2
• Aux 1 to Aux 48
• Frame Memory 1 to Frame Memory 16
• Clip Player 1 to Clip Player 4
Note
If you change the user region settings, the previously saved
snapshot data and effect timeline data can no longer be
used.
1
Open the Home > Setup > Switcher > Config > User
Region Config menu (19103.17).
2
Select the target region to set.
To select and set multiple regions, place a check mark
beside the target regions to set.
To select and set all regions, place a check mark in the
Select All checkbox.
3
Press the [User Region] button and select a user region
(User 1 to User 8) from the pull-down list.
When you do not want to assign a user region
Select [No Assign] from the pull-down list.
To return to the previous setting
Press the [Clear] button.
4
Press the [Apply] button.
5
Check the message, then press [OK].

Setting a Multi Viewer

A multi viewer is a function that splits the screen for
display of multiple images at the same time.
When the system signal format is 2160P, you can use one
multi viewer (multi viewer 1). When the system signal
format is 1080P or 1080i, you can use two multi viewers
(multi viewer 1, multi viewer 2).
Note
The multi viewer output image has a 2-frame delay.
1
Open the Home > Setup > Switcher > Multi Viewer
menu (19103.21).
2
Display the target multi viewer to set.
Select a tab to change the multi viewer to display.
[MV1] tab: Multi viewer 1
[MV2] tab: Multi viewer 2
3
Press the [Split Mode] button and select a split pattern
from the pull-down list.
You can select from eight patterns.
Split into 4: Split 4
Split into 10: Split 10-1, Split 10-2
Split into 13: Split 13-1, Split 13-2, Split 13-3, Split
13-4
Split into 16: Split 16
4
Set whether to display/hide a border using the [Enable
Border] button.
On: Display border lines on subscreen.
Off: Do not display border lines on subscreen.
Tally display
Tallies are shown on the multi viewer screen for the signals
used in the on-air image.
The tally is represented by subscreen borders using the
following three colors.
Red: Image with red tally (on-air tally)
Green: Image with green tally
Yellow: Image with yellow tally
Note
When [Independent] is selected in the [Tally Type] group
in the Home > Setup > Panel > Custom > Button Tally
menu (19104.64), tallies are not displayed on the multi
viewer screen.
309