Clip Transitions
Overview
You can play frame memory video content linked to a
background transition, such as a mix or wipe.
A key for a clip transition is mixed with the background
during execution of the transition.
Clip transition restrictions
• Pattern limits cannot be used.
• Transition preview cannot be used.
• It is not possible to set the transition rate of a clip
transition.
• A clip transition cannot be saved in an effect timeline as
a keyframe.
• The state of a clip transition during execution cannot be
saved in a snapshot.
• When recalling a snapshot that includes a clip transition
while executing another clip transition, the subsequent
transition does not operate properly. Recall the snapshot
after the transition completes.
• When recalling a DME wipe snapshot while executing a
clip transition, the image may be distorted.
• Transitions executed in two strokes, such as a preset
color mix when the stroke mode is set to normal mode,
or a DME wipe with a picture-in-picture pattern, will not
execute properly.
• When a clip transition is selected, the wipe direction
selection button in the transition control block that is lit
indicates the playback direction of the frame memory
clip.
Chapter
Setting a Clip Transition
This section describes clip transitions using frame memory
output channels 1 and 2 on M/E-1 as an example.
Selecting a Transition Type
You can select a clip transition on a frame memory output
channel to use using the transition control block or the
menu.
To select using the transition control block
Press a [FM1&FM2 CLIP] to [FM15&FM16 CLIP]
button, turning it on.
For frame memory output channels 1 and 2, press the
[FM1&FM2 CLIP] button, turning it on.
For details, see "Setting a transition type (transition
control block)" (page 58).
Note
When the system signal format is 2160P, only the
[FM1&FM2 CLIP] button, [FM3&FM4 CLIP] button, and
[FM5&FM6 CLIP] button can be selected.
To select using the menu
In the Home > M/E-1 > Bus/Transition > Transition >
Transition Type menu (11109.21), set a [FM 1&2 Clip] to
[FM 15&16 Clip] button in the [Transition Type] group to
the on state.
For frame memory output channels 1 and 2, set the [FM
1&2 Clip] button to the on state.
For details, see "Setting the key transition type (menu)"
(page 58).
Note
When the system signal format is 2160P, only the [FM
1&2 Clip] button, [FM 3&4 Clip] button, and [FM 5&6
Clip] button can be selected.
123
9