Setting The Display; Setting Utility Bus Mode - Sony XVS-G1 User Manual

Select a tab to change the switcher bank to display.
3
Set the on/off state of cross-point indicators using the
[Xpt Indicator] button.
On: Lit
Off: Not lit
Setting the color of cross-point buttons
You can set the color of the 3rd row/4th row cross-point
buttons.
1
Open the Home > Setup > Panel > Xpt Module >
Operation Mode menu (19104.31).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
In the [Xpt Button Color] group, select a color.
Source Color: Light up in the source color set for the
video signal.
For details about source color, see "Setting the Source
Color" (page 303).
White: Light up white.

Setting the Display

You can set the information that appears on the display in
the cross-point control block.
The display items and format can be selected for each of
six display modes.
1
Open the Home > Setup > Panel > Xpt Module >
Display Mode menu (19104.34).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
3
Select the target display mode (1 to 6) to set.
4
Split the display using the [Split] switch.
On: Split the display into two (upper and lower areas).
Off: Do not split the display.
5
Select the items to display.
When the [Split] switch is set to the on position
Press the [Upper Area] button and select an item to
display in the upper area from the pull-down list.
Press the [Lower Area] button and select an item to
display in the lower area from the pull-down list.
When the [Split] switch is set to the off position
Press the [Lower Area] button and select an item to
display from the pull-down list.
To make the display background gray
Set the [Gray Bkgd] switch to the on state.
To return the settings to the defaults
Press the [Default Recall] button, check the message, then
press [OK].

Setting Utility Bus Mode

In utility bus mode, you can set the bus assigned to the 1st
row to 4th row in the cross-point control block.
For details about utility bus mode, see "Utility bus mode"
(page 49).
1
Open the Home > Setup > Panel > Xpt Module > Util
Button Bus Assign menu (19104.35).
2
Display the target switcher bank to set.
Select a tab to change the switcher bank to display.
A list of button rows is shown on the left and a list of
assignable buses is shown on the right.
3
In the list on the left, select the target button row (1 to
4) to set.
4
In the list on the right, select a bus to assign.
5
Press the [Set] button.
To release the assignment
In the list on the left, select the target button row (1 to 4) to
release and press the [Clear] button.
To return the assignment to the defaults
Press the [Default Recall] button, check the message, then
press [OK].
321