Xcruze 110 Ap Setup Procedure; Pfd Display Setup; Manually Setting Dg - Honeywell BENDIXKing xCruze 110 Operating Handbook

5. XCruze 110 AP Setup Procedure

The display and autopilot parts of the XCruze 110 AP have
several user selectable values to help tune the instrument and flight
dynamics of the autopilot. Be sure to go through all of the screens
before the first flight using the autopilot as there are some safety
limits that need to be set.
5.1.
Before using your XCruze 110 Autopilot, there are a couple of
things on the PFD display that must be setup so that the instrument
can be used reliably. The setup screen for this is accessed via the
joystick control. Toggle and hold the joystick to the right until
VERTICAL ACT is shown then release the joystick. Next, toggle and
hold the joystick down until SET DG is shown.

5.1.1. Manually Setting DG

The DG on this product is slaved to the GPS to which it is
connected. In normal operation, no action is necessary here. In the
event of GPS output failure, the DG will turn red, indicating a lack of
GPS input. The DG will become an unslaved gyro at that time. This
setup menu allows the DG to be set to a compass heading.
With SET DG shown on the screen, rotate the knob to set the DG
to the desired value. Clockwise rotation numerically decreases the
number. The DG may drift off the set value, correcting this is
8300-089
Figure 4.2.2b

PFD Display Setup

14 Rev 3