Altitude Pre-Select Mode - Honeywell BENDIXKing xCruze 110 Operating Handbook

6.4.4. Altitude Pre-Select Mode

Sync the altimeter before performing
altitude pre-select (see section 6.1)
The altitude pre-select mode allows the user to pre-select a
target altitude before takeoff.
proceed in a climb to the selected target altitude and synchronize to
the current vertical speed, if greater than 500 fpm. Otherwise it will
choose 500 fpm. This mode is accessed by toggling the joystick to the
right one time while the autopilot is disengaged.
From autopilot disengaged, toggle the joystick to the right one
time, rotate the knob to select the target altitude, press the knob to
store the pre-selected altitude. The sequence for entering an altitude
pre-select is shown in figure 6.4.4a.
1) 100 foot increments when turning the knob.
8300-089
Toggle joystick to the right one time
Rotate knob
Once engaged, the autopilot will
43 Rev 3