Autopilot Lateral Setup; Lateral Activity - Honeywell BENDIXKing xCruze 110 Operating Handbook

5.2.
The lateral setup screen is accessed by toggling and holding the
joystick to the left for two seconds. Once in the lateral autopilot
setup menu, toggle the joystick to the right to advance the page,
toggle to the left to reverse the page, and rotate the knob to change
the value. Once lateral setup is completed, press the knob to exit.
The following sections are in the order in which you will encounter
them in the setup menu.

5.2.1. Lateral Activity

Selectable from 0 and 24. This setting controls the "sensitivity"
of the roll servo. A higher setting will increase the reaction speed,
too high will cause jitteriness. A lower setting will decrease reaction
speed, too low will cause sluggishness. Figure 5.2.1a shows the
LATERAL ACT adjustment screen.
8300-089
Figure 5.1.8a

Autopilot Lateral Setup

20 Rev 3