Control Wheel Steering Mode - Honeywell BENDIXKing xCruze 110 Operating Handbook

6.5.3. Control Wheel Steering Mode

This mode allows the autopilot to be temporarily disengaged to
make a quick course change and/or vertical speed change. This
mode is accessed by pressing and holding the control wheel steering
switch (if equipped). While the switch is held, the display will show
the autopilot is in CWS Mode. Figure 6.5.3a shows the CWS mode
screen.
When the button is released, the autopilot will hold the new
track and the new vertical speed, if greater than 400 fpm in either
direction. If the vertical speed at time of release is less than 400 fpm,
then the autopilot will hold zero vertical speed. Figure 6.5.3b shows
the screen after release at a vertical speed of 800 fpm up.
8300-089
Figure 6.5.3a
Figure 6.5.3b
50 Rev 3