Lateral Microactivity; Gpss Gain - Honeywell BENDIXKing xCruze 110 Operating Handbook

5.2.4. Lateral Microactivity

Selectable from 0 to 31. This setting is used to reduce the effects
of lost motion in the system. Cable operated systems will need to use
a higher value. Most pushrod control systems can use a value of 0.
Obtain factory assistance before making large adjustments to this
setting. The LMICRO ACT setup screen is shown in Figure 5.2.4a.

5.2.5. GPSS Gain

Selectable from 16 to 32. This setting is used to adjust the gain
of the GPS Steering signal from a source device. Increasing the
setting will result in a higher bank angle at a given point, up to the
maximum of the internal limiter. The GPSS GAIN setup screen is
shown in Figure 5.2.5a.
8300-089
Figure 5.2.4a
Figure 5.2.5a
22 Rev 3