Vertical Approach Mode - Honeywell BENDIXKing xCruze 110 Operating Handbook

6.4.6. Vertical Approach Mode

The vertical approach mode allows the autopilot to couple to and
track the glide slope of a GPS LPV approach.
available in GPSS mode. To access this mode, the autopilot must be
in GPSS mode and be in altitude hold mode (section 6.4.2) at the
proper altitude for the approach. Once altitude hold is reached, the
approach mode automatically engages. It is displayed by GPSV in the
top right of the autopilot display bar and GS ARM in the lower right.
When the glide slope is intercepted it will change to GPSV in the top
right of the autopilot display and GS CPLD in the lower right.
Figure 6.4.6a shows the sequencing on the display.
8300-089 46
This mode is only
Rev 3