Operation Keys And Their Functions - Hitachi REMOTE OPERATOR WOP Instruction Manual

2.2 Operation keys and their functions

In the case of connecting to WJ200 (Ver.2.0 or above) or NE-S1, key functions are shown in
Tab. 3.
Display mode transitions are described in section 4.1.
No. Key Name
1 REMOTE
2 READ
3 WRITE
4 ESC
5 SET

6
(1)

7 (2)
Chapter 2 Name of parts and functions of WOP
○
○
○
○
Tab. 3 Name and function of operation key
Remote key can change operation command and frequency
command method to the operator. Press the key more than 2
seconds, can change to the operator, and quit from operator after
press the key more than 2 seconds again.
The key is used to transfer inverter parameters to the WOP's
memory. (Refer to chapter 5 for more details.)
The key is used to copy the
(Refer to chapter 5 for more details.)
·Back to above layer.
·Cancel the change of
·Go ahead to below layer.
·When at edit layer, the change of set will be stored and back to
above layer via pressing the key.
·Cursor will move up, or function code will plus"1".
·Value will plus "1" when press the key.
·Cursor will move down, or function code will minus"1".
·Value will minus "1" when press the key.
○ ○
REMOTE OPERATOR
Function
parameter settings
parameter.
4
in WOP to inverter.