Operation Of Function Mode - Hitachi REMOTE OPERATOR WOP Instruction Manual

4.4 Operation of Function mode

1. Please select function mode via pressing the [] or []
key at navigation level. The cursor will not appear at this
layer.
2. Press the [SET] key to move to edit layer and the cursor
appears in the character of function group , And pressing
the [] or [] key to select the group that you want.
[change of function item of "F", "A", "b", "C", "H", "P", "U"
group]
Pressing the [] or [] key to move the cursor to the code
part of function item (F001 as right diagram), then pressing the
[] or [] key to change the function code.
3. It entries into the below layer after pressing the [SET] key.
Pressing the [] or [] key to select the data which you
want to set. It returns to the upper layer after storing
parameter via pressing the [SET] key. Pressing the [ESC]
key will cancel the change and returns to the upper layer.
Chapter 4 Operation
14
FUNCTION M1-STOP ALL
F001
Set Frequency(OPE)
6.00Hz
[0.00 - 50.00]
SET
ESC
FUNCTION M1-STOP ALL
F001
Set Frequency(OPE)
6.00Hz
[0.00 - 50.00]
 ×3
 ×3
FUNCTION M1-STOP ALL
F001
Set Frequency(OPE)
6.00Hz
[0.00 - 50.00]
SET
ESC SET
FUNCTION M1-STOP ALL
F001
Set Frequency(OPE)
006.00Hz
[0.00 - 50.00]