Operation Of Trip Mode - Hitachi REMOTE OPERATOR WOP Instruction Manual

4.5 Operation of Trip mode

1. Pressing the [] or [] key to select trip mode at
navigation layer.
2. Pressing the [SET] key entries into the below layer.This
mode will display the past trip information (6 times) and
warning information (1 time). Each trip information includes
two pages.
Display of no trip information
TRIP M1-STOP ALL
(no data)
SET
ESC
TRIP M1-STOP ALL
ERR1 P1
(no data)
(NOTE1) When trip happens, ALARM LED will be illuminated and the inverter can be reset via
pressing the [STOP/RESET] key.
(Parameter b087 decide the function of the [STOP/RESET] key)
(NOTE2) Because of different inverter states, trip time may be not saved and displayed.
(NOTE3) When trip happens, the backlight state becomes flicker whatever the state of
[Backlight Auto-off] is. (Refer to section 4.6)
Err1 Page2
TRIP M1-STOP ALL
ERR1 P2 UnderVoltage
DC Voltage
RUN time
ON time

Err2～5
Page2

Err6 Page2
TRIP M1-STOP ALL
ERR6 P2 UnderVoltage
DC Voltage
RUN time
ON time

WARNING M1-STOP ALL
Start FQ > Jog FQ
[b082] [A038]
15
Chapter 4 Operation
TRIP
E09.3
UnderVoltage
10/07/18 11:52
TRIP

ERR1 P1
172.3Vdc 10/07/18 11:52

3hr Output FQ
186hr Output current

Err2～5
Page1

TRIP
ERR6 P1

172.4Vdc 10/07/18 10:20 Accel.
3hr Output FQ

186hr Output current



M1-STOP ALL
Const.
SET
ESC
Err1 Page1
M1-STOP ALL
UnderVoltage
Const.
6.00Hz
0.00A
 
 
Err6 Page1
M1-STOP ALL
UnderVoltage
4.85Hz
0.00A