Operation Condition Of Read And Write Function - Hitachi REMOTE OPERATOR WOP Instruction Manual

5.6 Operation condition of read and write function

Please note that the read and write function are invalidated according to the state
and the setting of inverter as shown in below table.
The operation condition of reading or verifying parameter (WOP
State and setting of inverter
Inverter is running, EzSQ is
running, written unable.
Soft locked（b031）
Display is limited（b037）
Trip happened
The operation condition of writing parameter (WOP
State and setting of inverter
Inverter is running, EzSQ is
running, written unable.
Soft locked（b031）
Display is limited（b037）
Trip happened
In trip status: WRITE unavailable
TRIP M1-STOP ALL
E09.3
UnderVoltage
10/07/18 11:52 Const.
In running status: WRITE unavailable
MONITOR-A M1-FWD
d001 Output FQ
6.00Hz
F001 6.00Hz
（NOTE）When [R/W Storage Mode] is setted to [01: Single]. (Refer to section 4.6)
Chapter 5 Read, Write function and operation
Only parameter
Valid
Valid
Valid
Valid
Only parameter
Invalid
Invalid
Valid
Invalid
WRITE
WRITE
INV in TRIP mode
WRITE
ALL
WRITE
INV in RUN mode

Parameter+EzSQ
Valid
Valid
Valid
Valid
INV)

Parameter+EzSQ
Invalid
Invalid
Valid
Invalid
ESC
Press [ESC] key
ESC
Press [ESC] key
26
INV)
TRIP M1-STOP ALL
E09.3
UnderVoltage
10/07/18 11:52
MONITOR-A
d001 Output FQ
F001
Const.
M1-FWD ALL
6.00Hz
6.00Hz