Connect To Sj700,L700,X200 And Wj200 (Before Version 2.0) - Hitachi REMOTE OPERATOR WOP Instruction Manual

2.5 Connect to SJ700,L700,X200 and WJ200 (before Version 2.0)

Display contents and operation system of WOP are different according to the inverter type
that is connected to. When WOP is connected to SJ700, L700, X200 and WJ200 (before
Version 2.0), it displays in the same way of former remote operators such as SRW-OJ and
SRW-OEX. Otherwise, the differences of LED and functions of key are described in Tab. 6.
KEY & LED of WOP
REMOTE (Long push)
REMOTE (Short push)
READ
WRITE
ESC
SET
POWER LED
RUN LED
WARNING LED
ALARM LED
OPE LED
KEY ENABLED LED
○
RM=MON ESC=FUN SET=STR
FM
>F001
○
○
Chapter 2 Name of parts and functions of WOP
Tab. 6 Differences between former inverter
ＷJ200 (Ver.2.0 or above), NE-S1
Compulsion operation function effective / invalid
(No response because of absence
of the function)
Reading of parameter
Writing of parameter
Back to the upper layer
Store the setting value / Enter the
lower layer
Power on
Inverter is running
Warning happened
Inverter trip happened
The compulsion operation function is effective by the operator
Operation command key is effective
○ ○ ○
0000.00Hz
0010.00Hz
REMOTE OPERATOR
WOP
Fig. 3 Comparison of WOP and SRW-OJ/SRW-OEX
Move to monitor mode
（Monitor/MON key）
Reading of parameter
（Read/READ key）
Writing of parameter
（Copy/COPY key）
Move to function mode
（Function/FUN key）
Store the setting value
（Store/STR key）
（LED always turns off because of
absence of the function）
FM
>F001
SRW-OJ (the same as SRW-OEX)
8
L700, SJ700, X200
0000.00Hz
0010.00Hz