Operation Of Monitor Mode A - Hitachi REMOTE OPERATOR WOP Instruction Manual

4.2 Operation of Monitor mode A

1. Please select monitor mode A via pressing the [] or []
key at navigation layer. The cursor will not appear at this
layer until pressing the [SET] key.
2. After pressing the [SET] key at navigation layer, it moves
to edit layer and the cursor appears at the monitor code
part.
[change of Monitor item of "d" group]
Pressing the [] or [] key to select the function code to
display monitor item that you want.
[change of function item of "F", "A", "b", "C", "H", "P", "U"
group]
Pressing the [] or [] key to move the cursor to the code
part of function item (F001 as right figure), then pressing the
[] or [] key to change the function code.
3. It entries into the below layer after pressing the [SET] key
and the cursor appears on the parameter part of a function
item. Pressing the [] or [] key to change data. It returns
to the upper layer after storing parameter via pressing the
[SET] key. And the change is cancelled and returns to the
upper layer via pressing the [ESC] key.
Chapter 4 Operation
12
MONITOR-A M1-STOP ALL
d001 Output FQ
0.00Hz
F001 6.00Hz
SET
ESC
MONITOR-A M1-STOP ALL
d001 Output FQ
0.00Hz
F001 6.00Hz


MONITOR-A M1-STOP ALL
d002 Output current
0.00A
F001 6.00Hz
 ×4
 ×4
MONITOR-A M1-STOP ALL
d002 Output current
0.00A
F001 6.00Hz
SET
SET
ESC
MONITOR-A M1-STOP ALL
d002 Output current
0.00A
F001 006.00Hz