Table of Contents
Advertisement
No.
Item
8
Operator Reset
9
Check Mode
(NOTE1) When WOP (firmware version 1.00) connecting to WJ200 (Ver.2.0 or above), English ,
Japanese and Chinese are available, while connecting to L700, SJ700, X200 and
WJ200 (version before 2.0) or NE-S1, only English is available.
(NOTE 2) In the case of connecting to WJ200 (Ver.2.0 or above) or NE-S1, Clock display
function (d031) is provided as following diagram.
MONITOR-A
d031 Clock
07/18
F001
(NOTE 3) When [Read Lock] is setted to [01: Enable], READ operation is unavailable
(display as follows). Pressing [ESC] key will return to the previous display.
MONITOR-A
M1-STOP ALL
d001 Output FQ
0.00Hz
F001
6.00Hz
(NOTE4) When connecting to WJ200 (Ver.2.0 or above), please set [
[01: Type 1]. [read & copy only] will display if [02: Type 2] is selected.
(NOTE5) Please do not execute the [EEPROM Check]. Otherwise, the data (parameters/EzSQ
program) saved in WOP will be erased.
(NOTE6) Please do not execute the [Serial Loopback]. Communication check is not allowed
without proper tools.
Content
Resetting all the settings of WOP to
the default.
After reset operation, date and time
setting is required.
Checking whether LED and key etc.
are normal or not.
M1-STOP ALL
12:28
6.00Hz
READ
READ
Read lock enabled
Chapter 4 Operation
Setting range
01: YES
02: NO
1.Key & Led Check
2.Lcd Check
3.RTC Check
4.EEPROM Check(NOTE5)
5.Serial Loopback (NOTE6)
6.Debug Mode
7.Firmware Version
Press [ESC] key
18
MONITOR-A
d001 Output FQ
ESC
F001
] to
INV Type Select
Default
NO
-
M1-STOP ALL
0.00Hz
6.00Hz
Advertisement
Table of Contents
