Chapter 6 Inverter Setting Concerning Wop - Hitachi REMOTE OPERATOR WOP Instruction Manual

Chapter 6 Inverter setting concerning WOP

The example below explains parameter settings of WJ200 (Ver.2.0 or above) concerning
WOP.
No. Code Function name
Output frequency
1 F001
setting
2 A001 Frequency source
Run command
3 A002
source
Software lock
4 b031
mode selection
Function code
5 b037
display restriction
Initial display
6 b038
selection
Data R/W
7 b081
selection
8 b087 Stop key selection
Automatic return
9 b164 to the initial
display
C001
Intelligent Input
10
～
terminal function
C007
Chapter 6 Inverter setting concerning WOP
Tab.9 The parameter of inverter related to WOP
You could set the frequency when
the frequency instruction is done
from the operator.
Select the frequency instruction
source.
Select the run/stop command
source.
It is a function to prevent the
change in data.
Select the mode of the parameter
displayed in the operator.
Select the start display.
Restrict the data read/write by
operator.
Make the STOP key of operator
enable/disable.
It will change into the display which
set by initial display selection
(b038) automatically when no
operation to the operator within ten
minutes.
If it sets to 31(OPE) and the input is
turned on, the frequency instruction
and the run command source will
set to operator compulsorily.
If it sets to 51(F-TM) and the input
is turned on, the frequency
instruction and the run command
source will set to terminal
compulsorily.
It shows the display which set by
initial display selection (b038) when
it sets to 86(DISP) and the input is
turned on.
Content
Start FQ～ Max. FQ
00: VR
01: Terminal
02: Operator
03: Modbus
04: Option
06: Pulse
07: EzSQ
10: Math
01: Terminal
02: Operator
03: Modbus
04: Option
00: Lock(SFT)
01: Only FQ(SFT)
02: Lock
03: Only FQ
10: RUN chg mode
00: All
01: Utilize
02: User
03: Compare
04: Basic
05: Monitor
000: The last display after the [SET]
001～060: Display set by
201: Display of F001
202: Monitor mode B of WOP
00: Data read/write enable
01: Data read enable / write disable
02: Data read disable / write enable
03: Data read/write disable
00: Enable
01: Disable
02: Enable when reset a trip
00: Enable
01: Disable
31: Set to operator compulsorily
51: Set to terminal compulsorily
86: Display limitation
27
Setting parameter
key be pressed.
d001～d060